Olympia Above Ground Pools

Olympia Above Ground  Pools by Cornelius offer a rugged attractiveness, and construction system that would rival the wisdom of Athena

For our complete selection of Above Ground Pools click here

Flexible
Lightweight
Easy To Clean
Extends Pool Life
Installs In Minutes
Can Not Be Washed Out
Helps Prevent Corrosion
Over 20 Years Of Proven Performance
Eliminates Liner Failures Due To Cove Washout

Pool Cove is a 3 inch by 4 inch preformed cove made from a chemically neutral foam, and is safe for use with all pool liners. Lightweight and easy to handle, Pool Cove comes in 48 inch long sections that bend easily without breaking and are compatible with all pool brands. Its' unique black plastic backing strip makes it easy to install in all makes of pools. The plastic backing strip locks each section of cove into the bottom rail, allowing it to move as the pool wall expands and contracts. Unlike sand or dirt, Pool Cove can not be washed out and will not hold moisture against metal components. This feature reduces corrosion and may add years of life to a pool and its components. Because Pool Cove is made from a high density foam, it will not change shape or indent, making pool cleaning easier

Easy To Install
Extends Liner Life
Reduces Heat Loss
Makes Bottom Cleaning Easier
High Density/Low Compression
May Eliminate The Need For Sand
Helps Protect Pool Liners From Punctures
Great For Pool Set Up On Concrete
Minimizes Corrosion Of Metal Components

 Pool Pad can add years of life to a pool and its liner. Made from a special high density polyethylene foam, Pool Pad acts as a vapor barrier to keep potentially harmful water away from metal components. In addition, liner failure due to puncture is minimized and heat retention is improved. A smooth, easy to clean bottom and reduced indentations are just a few of the benefits of using Pool Pad.

 Pool Pad is easy to install. First, roll out sections of pad and cut them one foot longer than the (biggest if oval) dimension of the pool. Next, seam enough 4 ft. wide sections together with tape to cover the (smaller if oval) dimension of the pool. Finally, flip pad over so tape is facing the ground and build the entire pool on top of the pad. Trim off excess pad material after pool has been filled.